
Carpet tack Strip Installation
When installing tack strip for carpeting, something you will need is a hammer. Install tack strip for carpeting with assistance from a foreman for Lighty technicians inside no-cost video.
Address: Embed:
Video Transcript
Hello, everybody else, I'm Joshua Clement with Lighty technicians now i am gonna communicate with you about how to put in tack strip for your carpeting. Today with this work you will need a couple things. Because of this task you'll need a hammer as well as your tack strip. On most of the tack strips they usually have arrows suggesting which solution to point it towards wall. So we'll simply take; put the arrows towards the wall surface and begin an inch to an inch . 5 away from your wall. Very often i recently love to use my finger, about one joint of your little finger is an inch. Thus I'll just take my finger push it straight back indeed there and particular get it 1 inch away all the way down through there and I'll go on and drive the guts nail first. After that you view it keeps it in position also enables you to kind of bend it to be in a position to put the opposite side in 1 inch from your own wall. Then I'll go right to the opposite side and pull it out about 1 inches and drive it down into place and after that you'll go ahead and repeat this throughout the outsides of the wall surface, everywhere for which you have any wall space being released to the center of area. You should do it right along here also. I'm Joshua Clement with Lighty technicians therefore we simply discussed just how to put in tack stripping for your carpet. Thank you all for watching and good luck with this particular project.